Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Nikro Air Duct Cleaning in Austin: What to Know First
We provide independent Nikro air duct cleaning across Austin, and most Nikro jobs are completed in a single visit, typically three to five hours from setup to final walkthrough. Kestrel Air Duct Austin is not affiliated with or authorized by Nikro – we’re an independent Nikro service provider, which means we recommend what the system actually needs, never what a manufacturer’s program tells us to sell. Honest pricing comes before any work: most Austin homes with Nikro systems run between $450 and $900 for a full supply-and-return cleaning, depending on duct runs and access. This page is for Austin homeowners who own Nikro equipment and want a crew that knows the equipment by name, not by guesswork. Call (254) 848-6913 and you’ll get a live person who can schedule a free estimate.
Key Takeaways
- Nikro negative-air units pull contaminants from duct walls, but their filter configurations load differently than other brands – Austin’s cedar and limestone dust means filter changes mid-job on heavily soiled systems.
- We’re an independent Nikro service provider, never manufacturer-authorized, so our recommendations are based on what the ducts need.
- Most Austin Nikro duct cleaning jobs run $450 – $900, with a written price in your hands before a single vent is touched.
- Every Nikro cleaning carries the 365-Day Done Right Promise in writing – if it’s not done right, we return and make it right at no charge.
Styles & brands we work with




How Nikro Products Fail – and How We Fix Them
Nikro builds serious negative-air extraction equipment, but like any tool that moves large volumes of air and debris, it has wear points. Here’s what we see in Austin homes and how we address it on a Nikro duct cleaning job:
- Filter saturation on long runs. Nikro’s HEPA and primary filters load up faster than expected in Austin because cedar pollen and limestone dust are fine enough to pack into filter media quickly. When filters saturate, suction drops and the unit starts working against itself. We check filter condition before the cleaning starts, not after, and replace loaded filters so the negative-air pull stays strong through the entire job.
- Seal wear on the collection drum. Nikro’s collection drums use gaskets and seals around the lid and inlet. Over years of heat and use, those seals compress and leak, which reduces the vacuum the system can hold. A weak seal means debris gets loosened but not fully extracted. We inspect the drum seals on every Nikro cleaning and flag any loss of suction before the job goes further.
- Lint and dust bypass at the pre-filter. On systems that haven’t been cleaned in years, fine debris can work past the pre-filter and reach the main filter or blower. We see this most often on Nikro units paired with long flex-duct runs, where dust accumulates at the bends. We pre-check the duct layout and set up extraction points to catch debris at the source rather than letting it travel the full run.
- Clogged intake guards and screens. The intake side of Nikro units has guards that keep large debris from entering the hose. In Austin homes where previous cleanings were skipped or done poorly, we’ve found these screens caked with matted lint and construction dust. We clear them as part of the standard setup so the system can pull full air volume from the first minute.
- Hose wear at connection points. Nikro’s vacuum hoses take a beating. Cracks or loose cuffs at the connection points let air leak in, which drops suction exactly where it matters – at the duct wall. We bring replacement cuffs and hose sections on every job and swap them out without charging you for a part that keeps the job from being done right.
Our Nikro Air Duct Cleaning Process
Here’s what a Nikro air duct cleaning looks like when Kestrel Air Duct Austin runs the job:
- 1
Walkthrough and estimate. We walk the home, look at the duct layout, check the Nikro unit’s filter state and access points, and give you a written price before any work begins. No revisions at the door.
- 2
System sealing. We seal off registers and returns so the only path for loosened debris is into the Nikro extraction unit, not into your living space.
- 3
Negative-air extraction setup. We connect the Nikro unit at a strategic point in the duct system – usually at the plenum or a main trunk – so it pulls air through the entire run, not just the vent openings. Negative-air extraction means the system is under vacuum, so particles travel toward the unit instead of drifting back into rooms.
- 4
Brush agitation. We run Rotobrush rotary brushes through each duct run to dislodge debris at the duct wall. The brush loosens; the Nikro negative-air pulls it out. Both steps are necessary. Either one alone leaves too much behind.
- 5
Filter check and replacement. Partway through the job, we check the Nikro’s filters. On heavily soiled Austin systems, we swap in fresh filters mid-job so suction stays consistent.
- 6
Walkthrough and documentation. We show you the collection drum contents, confirm the registers are sealed back, and hand you the written 365-Day Done Right Promise. If anything falls short within a year, we return at no charge.
See the difference
Before
After
Before
After
Before
AfterWhat Nikro Air Duct Cleaning Costs in Austin
Most Nikro air duct cleaning jobs in Austin run between $450 and $900 for a full system cleaning, including supply ducts, return ducts, and the main trunk. Smaller homes with fewer runs fall at the lower end; larger homes or systems that haven’t been cleaned in five-plus years land at the higher end. What moves the price: the number of duct runs, whether returns are easily accessible, the condition of the Nikro unit’s filters and seals, and whether previous cleanings left compacted debris that requires extra brush passes. We give you the written price before work starts – always. Call (254) 848-6913 for a free estimate and we’ll get you an exact number for your system.
Why Austin Homeowners Call Kestrel Air Duct Austin for Nikro Work
Austin homeowners call us because they’ve been burned before. They’ve had a crew show up with a box-store shop vac and call it duct cleaning, or a company that quoted one price and changed it at the door. Kestrel Air Duct Austin runs under the Kingswell Guarantee, which means a written price before work starts, a defined arrival window, a clean job site, and the 365-Day Done Right Promise in writing on every job. Our technicians are background-checked and uniformed, and they use professional-grade equipment: Nikro negative-pressure units, Rotobrush rotary brushes, and Abatement Technologies HEPA filtration. If your home also has Lennox, Trane, or Carrier equipment, we service those brands too, so you’re not juggling multiple crews for one duct system. Dale Whitmore and his crew have been running jobs in Austin for years, and they’ll answer your questions in plain English, not trade jargon.
FAQs
No, cleaning your duct system with an independent provider like Kestrel Air Duct Austin will not void your Nikro equipment warranty. Air duct cleaning is a maintenance service, not a repair or modification to the Nikro unit itself. We inspect the system before and after cleaning, and we never alter the equipment. If you’re ever concerned, we’ll document the job fully so you have a record of exactly what was done.
We show you the collection drum contents before we seal everything back up, so you can see what came out of your ducts. We also check airflow at the registers before and after the job. On most Austin systems, you’ll notice the air moving more freely at the vents and less dust settling on furniture within a week or two. The 365-Day Done Right Promise backs the work in writing – if the ducts clog up again within the year, we return at no charge. Call (254) 848-6913 to schedule a free estimate.
Cheaper quotes usually mean fewer steps. A low-priced duct cleaning may skip brush agitation, run extraction only at the vent openings, or use equipment that can’t hold suction over a full duct run. If a quote comes in well under $450 for a full Austin home, ask what’s included: How many ducts are they actually cleaning? Are they sealing the system? Are they using a real negative-air unit? A partial job costs less up front and more later when the ducts clog again. We give you one written price for the full system, no per-vent games.
We schedule Nikro cleanings across Austin every week, and we’ll give you a defined arrival window when you book. For systems that haven’t been cleaned in five or more years, we plan extra time for the job because the filters will load faster and the brush passes take longer. The written estimate covers the extra work – you’ll know the full price before we touch a single vent.
We inspect the Nikro unit’s filters, seals, and hose connections on every job and flag anything that’s worn or loading too fast. If a filter needs replacing mid-job to keep suction strong, we swap it in. If a seal or hose cuff is compromised, we address it so the cleaning isn’t compromised. We don’t upsell replacements you don’t need – we show you the condition and let you decide. Call (254) 848-6913 for a free estimate and we’ll assess your system honestly.
Written by Dale Whitmore, Owner, Kestrel Air Duct Austin at Kestrel Air Duct Austin, serving Austin and nearby areas.